Wood gasification boiler DC30SX

The boiler body is made as a weldment from high-quality steel sheets with a thickness of 3 to 8 mm. It consists of a fuel hopper (6 mm), which is equipped with a gasification nozzle in the lower part with a longitudinal hole for the passage of flue gases and gases.

The combustion space below it is equipped with ceramic fittings for ideal combustion of all combustible substances with high efficiency in environmentally friendly combustion. In the rear part of the boiler body there is a vertical flue gas duct, equipped with a ignition valve in the upper part.

The upper part of the flue is equipped with an exhaust neck for connection to the chimney.

Advantages of Wood Gasification Boiler ATMOS

• Option to burn large pieces of wood 
• Large space for wood – long burning time – up to 12 hours, depending on boiler type
• High efficiency 87-92 % – primary and secondary air is preheated to a high temperature
• Ceramic combustion chamber
• Ecological burning – boiler class 5 – EN 303-5:2012, ECODESIGN 2015/1189
• Exhaust fan – dust-free ash removal, smokeless boiler room
• Cooling loop protecting against overheating – without risk of boiler damage ​ ​
• Automatic shutdown of the boiler after the fuel has burned out – flue gas thermostat
• Comfortable ash removing – large space for ash (when burning wood, clean it 1x / week)
• Boiler without tube heat exchanger – easier cleaning
• Small size and low weight
• Possibility of choosing a door R / L (right/left) for selected types
• Possibility of connection without accumulation tank
• High quality.

Panel composition:
Main off switch, safety thermostat, thermometer, regulator thermostat and combustion thermostat

Electro-mechanical regulation is an optimum solution for easy management of the operation of the boiler (ventilator). The design of the panel with standard regulation is a basic design for all produced boilers.

Specifications

Boiler heat output 30 kW
Boiler thermal input 33,4 kW
Heating surface 2,3 m2
Fuel shaft volume 95 dm3 (l)
Filling hole dimensions 450 x 260 mm
Prescripted chimney draft 24 / 0,24 Pa / mbar
Max. working water overpressure 250 / 2,5 kPa / bar
Boiler weight 332 kg
Gas-outlet pipe diameter 150 / 152 mm
Ingress protection of electric parts IP 20
Electrical power input (auxiliary) 50 W
Electrical input in standby mode 0 W
Ignition mode manual
Efficiency over the entire performance range 89,9%
Boiler class 5
Boiler category 1
Operating mode non-condensing
Energy efficiency class A+
Flue gas temperature at rated power 177°C
Waste gas combustion products flow weight at nominal output 0,017 kg/s
Specified fuel (preffered) Dry wood with a calorific value of 15-17 MJ/kg, water content 12-20 %, diameter 80-120 mm
Average consumption for the heating season 30 kg/h
Wood lenght 530 mm
Combustion time at nominal output 2 hours
The volume of water in the boiler 58 liters
Boiler hydraulic loss 0,21 mbar
Minimum buffer tank volume 500 liters
Connecting voltage 230/50 V / Hz 
EKODESIGN: yes