Aquathermica HPWH2.1 200 U02 S with a heat exchanger Air-to-Water Heat Pump Water Heater

Description

Tesy Aquathermica HPWH 2.1 200 U02 S with a heat exchanger Air-to-Water Heat Pump Water Heater for domestic hot water.

AquaThermica with a heat exchanger is an air-to-water heat pump water heater that can be connected to other energy sources, such as a boiler or solar system, for domestic hot water production.

• It is an environmentally friendly product, operating with renewable energy sources resulting in lower CO2 emissions[1].
• The highest energy efficiency class A+ in its category, according to ErP regulations.
• Operates within a wide temperature range of the incoming air starting from -10°C to 43°C.
• Heats up water to 65°C with the heat pump only.
• Electric heating element for faster heating up and reaching of higher temperature of 75°C
• Highly efficient[2] with a precisely balanced refrigerant cycle due to an electronically commutated motor and an electronic expansion valve.
• Up to 75% lower electricity consumption[3].
• Can be connected to other renewable energy sources like PV and solar systems or boilers.
• Programmable with an user friendly control panel
• Automatic anti-legionella cycle
• Self-diagnostic system

[1] According to the European Market and Statistical Report on the European Heat Pump Association 2018.
[2] AquaThermica is in Energy efficiency class A+
[3] Compared to a TESY product of the MaxEau family GCV 200 56 20 D06 SRC in Energy class C

Technical Data

Capacity 194 L
Insulation 50 mm
Energy class A+
Maximum operational temperature 75°C
Maximum working pressure 8 bar
Diameter 630 mm
Heating time 8:59 h:min
Declared load profile L
Electric heating element power 1.5 kW
HP maximum absorption 0.663 + 1.5 (e-heater) = 2.163 kW
Min. ÷ max temperature heat pump air intake (90% R.H.) -10 ÷ 43 °C
Frequency 50 Hz
Annual electricity consumption in kWh under average climate conditions 811.7 kWh
Power supply 230 V
Compressor Rotary
Min. ÷ max temperature installation site -10 ÷ 43 °C
Compressor protection Thermal circuit breaker with automatic reset
Maximum current in HP 3.1 + 6.5 (e-heater) = 9.6 A
Thermodynamic circuit protection type Safety pressure switch with automatic reset
Required overload protections 16A T fuse/ 16 A automatic switch characteristic C (to be expected during installation on power supply systems)
Fan Centrifugal
HP Maximum settable temperature 65 °C
Internal protection Single safety thermostat with manual reset on a resistive element
Nominal air capacity 314 m³/h
Max. pressure head available 50 Pa
Motor protection Internal thermal circuit breaker with automatic reset
Condenser Wrapped externally not in contact with water
Coil for connection to solar thermal power system 1.0 m²
Coil for connection to an auxiliary heating source N/A m²
Transport weight 112 kg
Sound power Lw (A) 53 dB(A)
Automatic anti-Legionnella disinfection cycle YES
Minimum height of the premise 1785 mm
Cathodic protection Mg anode Ø 32 x 400 mm
CoP (DHW) 2.9
Heat Pump Thermal Power yield (P rated) 1.1 kW
Degree of Protection IPX4
Refrigerant R134a
Refrigerant charge 880 g
CO2 equivalent 1287 t
Max. quantity of hot water at 40; V40; [EN16147:2017] 262 L
Average heat pump consumption [Condition EN16147:2017 A7/W55] 0.43 kW